Section 5, Provisioning - Cross-Connect Methods61189008L1-1B 5-5CROSS-CONNECT METHODSThe Cross-Connect menu (see Figure 5-1) allows provisioning of the 3/1 cross connect.Establish connections between the DS3s, rear panel DSX-1 drops, and module card DS1s asshown in Figure 3-1 on page 3-2. With some restrictions, any DS1 can be connected to anyother DS1. The restrictions are as follows:• DS1s in the same DS3 cannot be connected.• DS1 ports cannot be connected to other DS1 ports (DSX-1 drops).• DS1s on the same module cannot be connected.• No more than two DS1 ports (DSX-1 drops) can be connected to module DS1s.• All connections are two-way only. Only two DS1s can be part of any given connection. Athird DS1 cannot be added to a connection.Two methods are available to configure the cross-connect. The first method consists of threeviews that are accessed by the T hot key. The DS3 A and DS3 B views show DS3 connections(see Figure 5-1). The Drops view shows DS1 port and module connections (see Figure 5-2).Figure 5-1. Cross-Connect MenuCard: Controller A ADTRAN MX3216 System MM/DD/YY hh:mmUnacknowledged Alarms: NONE ID: Site 1 MX3216MX3216->Provisioning->Cross-ConnectDS3 A1 - T1 #1 = DS3 B T1 #1 15 - T1 #15 = DS3 B T1 #152 - T1 #2 = DS3 B T1 #2 16 - T1 #16 = DS3 B T1 #163 - T1 #3 = DS3 B T1 #3 17 - T1 #17 = DS3 B T1 #174 - T1 #4 = DS3 B T1 #4 18 - T1 #18 = DS3 B T1 #185 - T1 #5 = DS3 B T1 #5 19 - T1 #19 = DS3 B T1 #196 - T1 #6 = DS3 B T1 #6 20 - T1 #20 = DS3 B T1 #207 - T1 #7 = DS3 B T1 #7 21 - T1 #21 = DS3 B T1 #218 - T1 #8 = DS3 B T1 #8 22 - T1 #22 = DS3 B T1 #229 - T1 #9 = DS3 B T1 #9 23 - T1 #23 = DS3 B T1 #2310 - T1 #10 = DS3 B T1 #10 24 - T1 #24 = DS3 B T1 #2411 - T1 #11 = DS3 B T1 #11 25 - T1 #25 = DS3 B T1 #2512 - T1 #12 = DS3 B T1 #12 26 - T1 #26 = DS3 B T1 #2613 - T1 #13 = DS3 B T1 #13 27 - T1 #27 = DS3 B T1 #2714 - T1 #14 = DS3 B T1 #14 28 - T1 #28 = DS3 B T1 #28(T)oggle View (DS3 B, Drops) (V)iew MapSelection : '?' - System Help Screen
