Drop and Continue Application MX410/MX412 System Manual3-4 PRELIMINARY 61189500L1-1BSetupConnect the incoming DS1 (the DS1 from which the DS0s are dropped) to the DS1 1 RJ.Connect the outgoing DS1 to the DS1 2 RJ. Connect the other DS1s using the RJ connectoron the front panel. For more information, refer to ìDS1 Portsî on page 4-6.Starting from the default blank mapping, the DS0s can be dropped using the Quick Setupmenu to the PPP and V.35 ports (see Figure 3-3). Select each port (PPP1-4, V.35) to which aDS0 needs to be dropped from the incoming DS1. For each port, select the range of DS0s inDS1 1 to be dropped to that port. To drop DS0s to the other DS1 ports, use the Quick Setupmenu to navigate to the Cross-Connect Mapping menu. Select the Map Multiple DS0ís optionand then select the range of DS0 and DS1 1 to be dropped to DS1 2 and enable Robbed BitSignaling if applicable.Any un-mapped DS0s from the incoming DS1 will transmit All Ones. The incoming DS1 doesnot have to be DS1 1, but is used only as an example.The following four figures show an example of setting up a drop and continue application.Figure 3-3 shows the Quick Setup menu before any DS0s have been dropped.Figure 3-3. Quick Setup MenuMX410 MM/DD/YY HH:MMActive Alarms: CRITICAL MINOR ID: MX410Quick SetupPorts1 - PPPsPPP 1 = DS1 4 DS0 #12 - V.35 =System3 - System ID4 - IP Address : 192.168.100.1Subnet Mask : 255.255.0.05 - Default Gateway : 192.168.1.16 - Date7 - Time 8 - Cross-Connect MappingSelection : '?' - System Help Screen
