Remote Management of Other Systems using Terminal Server Ports and Ethernet Connectivity MX410/MX412 System Manual3-18 PRELIMINARY 61189500L1-1BRemote Management of Other Systems using Terminal ServerPorts and Ethernet ConnectivityIn this application the Terminal Server ports on the MX410 are used to provide remotemanagement of other non-Ethernet based equipment at the same site. This requiresconnecting the RS-232 craft ports of the other equipment to the Terminal Server ports of theMX410. Establishing a Telnet session to the MX410 Terminal Server ports establishes accessto the other equipment. Up to four external devices can be accessed in this way.The Ethernet ports on the MX410 are used to provide remote management of the otherEthernet based equipment. This requires connecting the Ethernet ports of the otherequipment to the Ethernet ports on the MX410 (see Figure 3-23). Refer to ìPPP BCP/IPCPMenuî on page 5-32 for more information about PPP and IP.Figure 3-23. MX410 Remote Management of Other SystemsThe equipment needed for a Remote Management application is shown in Table 3-4.Table 3-4. Remote Management Application - Required EquipmentPart Number Equipment Quantity1189500L1or1189512L1MX410MX412111189501L1 MX410 PSU (MX410 only) 1 (2 for redundancy)Other SystemsCurrently Managedby the MX410 viaEthernet Port toEthernet PortConnectionsTechnicianManages AllMX410 Unitsand Other Systemsfrom Any Cell SiteOther SystemsCurrently Managedby the MX410 viaTerminal Server Portto RS-232 Craft PortConnectionsMX410IPEthernet PortsEthernet PortsTerminal Server PortsRS-232 PortsDS1μ Wave/LeasedDS1Original DS0sContinueDownstream;All Ones inUnmapped DS0sDS1μ Wave/LeasedDS1Original DS0sContinueDownstream;All Ones inUnmapped DS0sDS1 DS1DS1 DS1EthernetSwitchMX410
