ADTRAN TRACER 6000 SERIES User Manual

Also see for TRACER 6000 SERIES: System manual

Contents

ADTRAN TRACER 6000 SERIES User Manual Manual pdf 105 page image

612806320L1-1B Copyright © 2005 ADTRAN, Inc. 105DLP-6 Updating the Firmware Using XMODEMIntroductionThe TRACER 6000 Series split system supports firmware updates of the local and remote systems usingTFTP or XMODEM. Use the TRACER 6200 10/100BaseT/TX MGMT port and TFTP from a networkserver or XMODEM (if your Telnet client supports file transfers), or use XMODEM and the CRAFTinterface. This procedure outlines the steps for a successful firmware upgrade using the CRAFT interfaceand XMODEM software. The same XMODEM steps apply for file transfers through your Telnet client(refer to your Telnet client documentation for more details on file transfer specifics). (See DLP-5,Updating the Firmware Using TFTP, on page 101 for instructions on using TFTP.)Tools and Materials Required• VT100 terminal or PC with VT100 terminal emulation software• XMODEM softwareTo prevent electrical shock, do not install equipment in a wet location or during alightning stormElectronic equipment can be damaged by static electrical discharge. Before handling it,put on an antistatic discharge wrist strap to prevent damage to electronic components.Place equipment in antistatic packing material when transporting or storing. Whenworking on equipment, always place it on an approved antistatic mat that is electricallygrounded.