612806320L1-1B Copyright © 2005 ADTRAN, Inc. 99DLP-4 Verifying Communications Over an IP LANIntroductionWhen the 10/100BaseT/TX MGMT port is connected to a local area network (LAN), test steps must beperformed on the TRACER 6200 to ensure that the unit is communicating properly over the network. Thisprocedure outlines those steps.Prerequisite ProceduresBefore beginning this procedure, the unit should be physically connected to the LAN and the provisioningtasks detailed in DLP-3, Setting IP Parameters for the TRACER System, on page 95 should be complete.Tools and Materials Required• Access to a PC or other computer connected to the LANTo prevent electrical shock, do not install equipment in a wet location or during alightning storm.Electronic equipment can be damaged by static electrical discharge. Before handling it,put on an antistatic discharge wrist strap to prevent damage to electronic components.Place equipment in antistatic packing material when transporting or storing. Whenworking on equipment, always place it on an approved antistatic mat that is electricallygrounded.
