In certain programmes the spin speed has not effect (time controlled cycles), itsselection can be not selectable and only three dashes are visualized. Available se-lections: from 800 to 1800 rpm's in 100 rpm's intervals.The maximum value depends by selected program, the minimum is always 800 rpmFor those programs where the spin speed has no effect (time controlled cycles), theselection is not allowed and three dashes “- - -” are displayed that has the meaningof not set or unknown.The user interface always remembers last spin selection, and proposes it as defaultfor all new selected programs. If memorized spin speed is greater than maximumallowed value it will be automatically reduced to max spin speed available for theselected program.Setting DELAY (STARTUITSTEL) functionWith the DELAY (START UITSTEL) button, you can delay the start of a ProSteam programme by between 30 minutes and a maximum of 20 hours.1. Select the programme and additional functions/options if necessary.2. Press the DELAY (STARTUITSTEL)button as many times as necessary.During selection, END TIME of the cycle increases in the display and delayicon is on.If you reach 20 hours of start delay and you press the button again, the timedelay is cancelled and delay icon disappears.3. To activate the delay timer, press the START PAUSE (START PAUZE) button. Theamount of time remaining until the programme is set to start is continuouslydisplayed (e.g. 5:00 hours, 4:59… 0:30 minutes etc).The message Delay Start and delay icon is on.Starting the Pro Steam programmePress the START PAUSE (START/PAUZE) button. The programme starts.The progress bar and the name of currently performed phase, above it, show stageof the cycle.With wet laundry, after a few minutes the appliance will show the correct pro-gramme duration for the Pro Steam programme including the preceding dryingprogramme.25