The display shows the set temperature,the symbol and the number of the ovenfunction.2. Touch or to set an ovenfunction.3. Touch or the appliance startsautomatically after five seconds.If you activate the applianceand do not set an ovenfunction or programme, theappliance deactivatesautomatically after 20seconds.6.4 Changing the temperatureTouch or to change thetemperature in steps of 5 °C.When the appliance is at the settemperature, an acoustic signal soundsthree times and the Heat up indicatorgoes out.6.5 Checking the temperatureYou can see the temperature in theappliance when the function orprogramme operates.1. Touch .The Temperature / Time display showsthe temperature in the appliance.2. Touch to go back to the settemperature or the display shows itautomatically after five seconds.6.6 Fast heat up functionDo not put food in the ovenwhen the Fast heat upfunction operates.The Fast heat up function is not availablewith every oven function. An acousticsignal sounds if the Fast heat up functionis not available for the set function ifFaulty tone is activated in the settingsmenu. Refer to "Using the settingsmenu".The Fast heat up function decreases theheat up time.To activate the Fast heat up functiontouch and hold for more than threeseconds.If you activate the Fast heat up function,the bars on the display flash one byone and comes on to show thatthe function operates.6.7 Steam cookingThe water drawer cover is in the controlpanel.WARNING!Use only water as the liquid.Do not use filtered(demineralised) or distilledwater.1. Press the cover of the water drawerto open it.2. Fill the water drawer with cold waterto the maximum level (around 950ml) until the acoustic signal sounds orthe display shows the message.The water supply is sufficient forapproximately 50 minutes.Do not fill the water drawer over itsmaximum capacity. There is a risk ofwater leakage, overflow and furnituredamages.3. Push the water drawer to its initialposition.4. Activate the appliance.5. Set the steam function (refer to the"Oven functions" table) and thetemperature.6. If necessary, touch to set theDURATION or END function(refer to "Setting the END" or"Setting the DURATION").The first steam shows afterapproximately 2 minutes. An acousticsignal sounds when the appliance is atapproximately the set temperature. Thesignal sounds again at the end of thecooking time.7. Touch to deactivate the acousticsignal and the appliance.ENGLISH 13