AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000Page 82 01/2011 Description et caractéristiques d’un PBXTABLEAU 3.2 LIST OF AXD IPBX SUBASSEMBLIES(1) If this figure is reached: equipment cards cannot be installed. If the number of CLX cards is below 12: any equipmentcard can be added.(2) A - max number of LT2 = 6B - max number of IPS = 1C- max number of PT2 (32 V) = 4D - max number of PT2 (32 V) + LT2 = 8E- max number of DECT base stations = 40 (10 LD4N in X mode, with iPBX software release R4.1 – Other cases:max number of base stations = 24)F- max number of CLX (LD4N in X mode with iPBX software release 4.1 min, LT2, PT2, CP1, CS1, CA1, MUM) = 12G- max number of CLX (case of LD4 or LD4N not in X mode, LT2, PT2, CP1, CS1, CA1, MUM) = 10If case F is reached (CLX = 12), no other card is accepted in the main cabinet.If case G is reached (CLX = 10), no other card is accepted in the main cabinet.(3) The LD4, LD4N, LD4X and LT2 synchronising cards must be located in slots 0 to 5 of the AXD main cabinet whenthey are to be used to provide the carrier (RTCP) reference clocks for the main card.3.4.2 Aastra XS/XLThe subassemblies in each of the AXL, AXS, AXS12 and AXS6 iPBXs are presented in atree in 3.3.Nota : The quantities indicated are the maximum hardware and software quantities foreach type of card. These quantities also depend on the configuration rules(see Section3.5 ) and engineering rules of each site.Simplex12 12 12Simplex with secure powersupplyDuplexLI1Simplex12 12 12Simplex with secure powersupplyDuplexBTXSimplex1 1 1 1Simplex with secure powersupplyDuplexSUBASSEMBLIES AXLMain CabinetA2XL A3XL AXSCabinetMainA2XS AXS12 maincabinetAXS6 maincabinetPower supply module 1 2 3 1 2 1 1Battery (option) 1 2 3 1 2 1 1Subassemblies MAIN CABINETAXDAXD EXPANSIONCABINETA2XD A3XDList of the sub-assemlies in AXD iPBXs - Folio 6 de 6 -
