CHAPTER 2 | Installing the RG211Mounting on a Wall– 24 –MOUNTING ON A WALLTo mount on a wall follow the instructions below.Figure 7: Wall MountingThe RG211 should be mounted only to a wall or wood surface that is atleast 1/2-inch plywood or its equivalent. To mount the RG211 on a wall,always use its wall-mounting bracket. The RG211 must be mounted withthe RJ-45 cable connector oriented upwards to ensure proper operation.1. Mark the position of the three screw holes on the wall. For concrete orbrick walls, you will need to drill holes and insert wall plugs for thescrews.2. Insert the included 20-mm M4 tap screws into the holes, leaving about2-3 mm clearance from the wall.3. Line up the three mounting points on the AP with the screws in the wall,then slide the AP down onto the screws until it is in a secured position.Mounting Slots
