Command Line Interface4-84Interface CommandsThese commands are used to display or set communication parameters for anEthernet port, aggregated link, or VLAN.interfaceThis command configures an interface type and enter interface configuration mode.Use the no form to remove a trunk.Syntaxinterface interfaceno interface port-channel channel-idinterface• ethernet unit/port- unit - This is device 1.- port - Port number.• port-channel channel-id (Value: 1)• vlan vlan-id (Range: 1-4093)Default SettingNoneCommand Function Mode Pageinterface Configures an interface type and enters interface configurationmodeGC 4-84description Adds a description to an interface configuration IC 4-85speed-duplex Configures the speed and duplex operation of a given interfacewhen autonegotiation is disabledIC 4-85negotiation Enables autonegotiation of a given interface IC 4-86capabilities Advertises the capabilities of a given interface for use inautonegotiationIC 4-87flowcontrol Enables flow control on a given interface IC 4-88combo-forced-mode Force port type selected for combination ports IC 4-89shutdown Disables an interface IC 4-89switchport broadcastpacket-rate Configures the broadcast storm control threshold IC 4-89clear counters Clears statistics on an interface PE 4-90show interfaces status Displays status for the specified interface NE, PE 4-91show interfacescountersDisplays statistics for the specified interfaces NE, PE 4-92show interfacesswitchportDisplays the administrative and operational status of aninterfaceNE, PE 4-93
