Configuring the Switch3-38CLI – This example sets the authentication mode to enable 802.1x on port 2, andallows up to ten clients to connect to this port.Displaying 802.1x StatisticsThis switch can display statistics for dot1x protocol exchanges for any port.Statistical ValuesWeb – Select Security, 802.1x, Statistics. Select the required port and then clickQuery. Click Refresh to update the statistics.Console(config)#interface ethernet 1/2 4-84Console(config-if)#dot1x port-control auto 4-70Console(config-if)#dot1x operation-mode multi-host max-count 10 4-70Console(config-if)#Parameter DescriptionRx EXPOL Start The number of EAPOL Start frames that have been received by thisAuthenticator.Rx EAPOL Logoff The number of EAPOL Logoff frames that have been received by thisAuthenticator.Rx EAPOL Invalid The number of EAPOL frames that have been received by thisAuthenticator in which the frame type is not recognized.Rx EAPOL Total The number of valid EAPOL frames of any type that have been receivedby this Authenticator.Rx EAP Resp/Id The number of EAP Resp/Id frames that have been received by thisAuthenticator.Rx EAP Resp/Oth The number of valid EAP Response frames (other than Resp/Id frames)that have been received by this Authenticator.Rx EAP LenError The number of EAPOL frames that have been received by thisAuthenticator in which the Packet Body Length field is invalid.Rx Last EAPOLVer The protocol version number carried in the most recently received EAPOLframe.Rx Last EAPOLSrc The source MAC address carried in the most recently received EAPOLframe.Tx EAPOL Total The number of EAPOL frames of any type that have been transmitted bythis Authenticator.Tx EAP Req/Id The number of EAP Req/Id frames that have been transmitted by thisAuthenticator.Tx EAP Req/Oth The number of EAP Request frames (other than Rq/Id frames) that havebeen transmitted by this Authenticator.
