3 Server Blades: Setup and Installation166BIOS UpdatesIt may be necessary to update the BIOS used in the blade modules onoccasion. However, it is recommended that you not update BIOS if youare not experiencing problems with a blade module.There are several methods you may use to upgrade (flash) your BIOS.After downloading the appropriate BIOS file (in a zip file format),follow one of the methods described below to flash the new BIOS.Flashing BIOSUse the procedures below to “Flash” your BIOS with a new updateusing the KVM dongle, USB ports on the CMM module or by use of aFloppy disk.Flashing a BIOS using the KVM Dongle:For this method, you must use a KVM cable (included with the system).1. Copy the contents of the zip file to a bootable USB pen drive.2. Connect the KVM cable to the KVM connector at the front of theblade you will be flashing the BIOS to.3. Connect your bootable USB pen drive to one of the two USB slotson the KVM dongle.4. Boot to the USB pen drive and go to the directory where you savedthe contents of the zip file.5. Type flash filename.rom (replacefilename.rom by the actual ROMfile name).Flashing a BIOS using the USB Ports on the CMM:1. Copy the contents of the zip file to a bootable USB pen drive.2. Connect your bootable USB pen drive to one of the two USB slotson the CMM (located on the back side of the enclosure).3. Boot to the USB pen drive and go to the directory where you savedthe contents of the zip file.4. Type flash filename.rom (replacefilename.rom by the actual ROMfile name).
