7111 Click Save to save the changes.12 Click Close to return to the BMC LAN Configuration window.13 To send a test alert to verify that you have correctly configuredBMC LAN alerts, from the Options menu, choose Send Alert.14 Click Save to save the changes.15 Click Close to return to the PEM window.Managing the Server RemotelyYou can set up the server so that you can connect to it from a remoteclient system to perform management tasks. You can make theconnection over a LAN or by using a modem or direct serial cable tothe Emergency Management Port (EMP). Instructions for setting up theserver for remote LAN and serial/modem access are given below.Setting Up Remote LAN AccessTo configure remote LAN access:1 From the SSU Main window, choose Platform Event Manager(PEM).2 In the PEM window, click Configure LAN and fill in the boxesdescribed in the following steps (boxes that aren’t listed here arenot required for remote access).3 To require a password for remote access, enter the password in theEnter New Password box and in the Verify New Password box.Passwords can be from 1 to 16 characters long, using any ASCIIcharacter in the range [32-126]. To clear the passwords, leave bothboxes blank. (You can also clear the password by choose the menuOptions > Clear LAN Password.)4 From the LAN Access Mode list, select the remote access mode:• Full Access: a remote system can initiate a LAN connectionregardless of the state or health of the server.• Restricted: a remote system can initiate a LAN connection,but cannot perform control operations such as power down,reset, or front panel NMI.• Disabled: remote systems are not allowed to initiate LANconnections.5 In the IP Setup box, choose either:
