7Siga estos pasos para conectar sus dispositivos internos Ultra320/160 y Ultra2:1 Busque un cable SCSI LVD interno de 68 clavijas, bien concables entrelazados o planos, tal y como se aprecia en la imagen.2 Introduzca el extremo sin terminación del cable o cables en elconector LVD interno.Extremo sinterminaciónExtremo con terminación

setting up scsi devices

connecting scsi devices

troubleshooting

risoluzione dei problemi

Adaptec 29320ALP-R Installation Manual

Ultra320 SCSI on the Adaptec SCSI Card

Device Drivers

HostRAID on Adaptec SCSI Cards

Storage Management Software

Operating Systems

System Requirements

Understanding SCSI

Terminating the SCSI Bus

Defining RAID

Supported RAID Levels

Using SCSI Devices

Using Ultra320/Ultra160 Hard Disk Drives

Combining SCSI and Non-SCSI Devices

Installing Multiple SCSI Cards

Connecting the LED Connector

Adaptec SCSI Card 39320A

Adaptec SCSI Card 29320ALP

adaptec scsi card 29320a

internal connector

Maximum Cable Lengths

Starting SCSISelect

Exiting SCSISelect

Only

SCSI Device Configuration Options

Advanced Configuration Options

Error Messages

HostRAID Options

Changing Configuration Settings

scsi device configuration

Using SCSI Disk Utilities

Verifying or Formatting a Disk

Using the SCSISelect Utility

Viewing Array

Creating RAID 0 Arrays

Creating RAID 1 Arrays

Creating RAID 10 Arrays

Deleting Arrays

Rebuilding Arrays

Verifying Data Integrity

Bootable Array

Installing the Device Driver for Windows

Installing the Driver When Windows 2000 or Windows Server 2003 is Already Installed

Installed

Windows 2000/2003/XP Installation and Configuration Notes

Installing the HostRAID Driver for Windows NT

Installing the Driver for Windows NT 4.0

Windows NT 4.0 Installation and Configuration Notes

Management

Installing Red Hat Linux

Installing the Red Hat Driver in a New Linux System

Installing SuSE Linux

Installing the Driver When Installing Windows

Updating the Driver When Windows is Already Installed

Upgrading a Windows NT 4.0 or Windows 2000 Installation to Windows Server 2003

Already Installed

Removing a Host Adapter

more information

Troubleshooting

Installing the SCSI Driver for Windows NT

Installing the Driver When Installing Windows NT

Updating Windows NT 4.0

Using Advanced Configuration Parameters

Using Windows NT 4.0 and the Host Adapter

Swapping a Host Adapter

Problems and Solutions

for novell netware

Installing the Driver When Installing NetWare

Loading the Driver at Server Bootup

Using the Load Command Line Options

Sample Load Commands

Using the NetWare Tape Backup

Using a CD with NetWare

Installing the Driver When UnixWare/Open Unix is Already Installed

Back Up the Kernel

Modify the New System File

Boot the New Kernel

Installing the Driver When Installing OpenServer

Using UnixWare/Open Unix and the Host Adapter

Removing the Driver

for sun solaris

Installing the Driver When Installing Solaris 9

Installing the Driver When Solaris 9 is Already Installed

Removing the Driver From Solaris 9

Additional Notes

29320A

29320ALP-R - SCSI Card Storage Controller U320 320 MBps


Contents setting up scsi devices connecting scsi devices troubleshooting risoluzione dei problemi	7Siga estos pasos para conectar sus dispositivos internos Ultra320/160 y Ultra2:1 Busque un cable SCSI LVD interno de 68 clavijas, bien concables entrelazados o planos, tal y como se aprecia en la imagen.2 Introduzca el extremo sin terminación del cable o cables en elconector LVD interno.Extremo sinterminaciónExtremo con terminación Previous Next / 83