Chapter 10: Updating and Customizing Adaptec Storage Manager ● 131The Adaptec Storage Manager Agent General Settings window opens for the system youselected. The auto-discovery settings appear at the bottom:3 To enable/disable auto-discovery, select Enable auto-discovery. (This option togglesbetween enabled and disabled.)4 Update the auto-discovery settings, as required:● In the Auto discovery scopes field, enter a comma-separated list of scopes. To bediscovered by the auto-discovery task, the local system and remote system must have atleast one scope in common. The default scope for an Adaptec Storage Manager Agentis Auto Discovery.● In the Auto discovery base port number field, enter the port’s TCP/IP address. You canuse any port for auto-discovery. However, to use an existing SLP infrastructure, youmust use port 427. The default port is 34570. If you change the port, you must restartthe Adaptec Storage Manager Agent for the change to take effect.● In the Auto discovery heartbeat interval field, enter the number of seconds betweeneach auto-discovery check. This number determines how often Adaptec StorageManager checks for changes in remote system resources. The default is 360 seconds.● In the SLP Directory Agent address field, enter the TCP/IP address of the SLPDirectory Agent. Applies only if you specified port 427 for an existing SLPinfrastructure.5 Click Save Changes.Working with Display GroupsYou can organize related local and remote systems into display groups within the EnterpriseView to make monitoring and modifying your storage space faster, easier, and more efficient.Once display groups are created, they’re sorted alphabetically and appear in the EnterpriseView below any systems that are not part of a display group.A system can belong to only one display group at a time; you can’t include the same system inmultiple display groups.Follow the instructions in this section to:
