Adaptec CDP-00277-01-A Installation And User Manual

Also see for ASR-71605: User guide

Contents

4. Assuming the USB drive is assigned to /dev/sda1, type the following commands to begin loadingthe driver:mkdir /AACRAIDmount /dev/sda1 /mntcp -R /mnt/* /AACRAIDumount /mntNote: The following steps assume you are installing Ubuntu 10 or 11, using kernel2.6.32-28. For Ubuntu 12 or higher, the driver files aacraid.ko-PRE_MOD andaacraid.ko-POST_MOD are both replaced by the single file aacraid.ko.5. Copy the driver file to the /lib/modules directory:cp -f /AACRAID/aacraid.ko-PRE_MOD/lib/modules/2.6.32-28-generic/kernel/drivers/scsi/aacraid/aacraid.ko6. Remove the USB drive.7. Install the loadable module:insmod /lib/modules/2.6.32-28-generic/kernel/drivers/scsi/aacraid/aacraid.ko8. Press CTRL+ALT+F1 to switch back to the installation screen, then follow the on-screen promptsto continue the installation.Note: Do not press Continue at the end of the installation until you complete Step9!9. When prompted to reboot the system, press CTRL+ALT+F2 to switch to the console.10. Type the following commands to complete the driver installation:Ubuntu 32-bit:cp -f /AACRAID/aacraid.ko-POST_MOD/target/lib/modules/2.6.32-28-generic-pae/kernel/drivers/scsi/aacraid/aacraid.kochroot /target/sbin/depmod -a 2.6.32-28-generic-paeupdate-initramfs -u -vexitUbuntu 64-bit:cp -f /AACRAID/aacraid.ko-POST_MOD/target/lib/modules/2.6.32-28-server/kernel/drivers/scsi/aacraid/aacraid.kochroot /target /sbin/depmod -a 2.6.32-28-serverupdate-initramfs -u -vexit11. Press CTRL+ALT+F1 to switch back to the installation screen, then reboot.12. Continue with Managing Your Storage Space on page 54.Installing with SolarisNote: This task is not necessary if you are installing Solaris 10 Update 2 or later.Instead, you can choose to install Solaris using the in-box driver and update it eitherduring or after the installation is complete, if required.Note: If necessary, you can create a driver disk by burning a CD with theaac_solaris-x86.iso file, available on the Adaptec Installation DVD.To install the Adaptec RAID controller driver while installing Solaris:1. Start your computer.45Proprietary and Confidential to PMC-Sierra, Inc.Document No.: CDP-00277-01-A Rev. A, Issue:Serial Attached SCSI RAID Controllers Installation and User's Guide