9-3Managing ControllersTo shut down a controller:1 In the System Browser window, select the controller you want toshut down.2 Click Shutdown Controller.3 Reboot from the Operator Control Panel of the RAID appliance,or from Adaptec Disk Array Administrator via Hyperterminal.See Shutting Down the Other Controller on page 9-13 and ShuttingDown Both Controllers on page 9-13 for additional, active-activeconfiguration commands.Rebooting a ControllerRebooting a controller shuts it down, then restarts it. You may needto do this after making configuration or hardware changes.To reboot a controller:1 In the System Browser window, select the controller you want toreboot.2 Click Reboot Controller.The system performs its self-test. The controller will disappearfrom the System Browser window. When it reappears, the reboot iscomplete.See Rebooting the Other Controller on page 9-14 and Rebooting BothControllers on page 9-14 for additional, active-active configurationcommands.Restoring Controller DefaultsYou can restore all of a controller’s default settings. You may wantto do this if the controller is not working properly and you cannotdetermine the reason why. You can then change the settings thatare critical to your configuration.To restore the controller default settings:1 In the System Browser window, select the controller whosedefaults you want to restore.2 Click Restore Controller Defaults.
