N.3 Assignment of the LED connectors ......................................................................... 292N.4 Index ........................................................................................................................ 293FCC Compliance StatementInformation for the UserNOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in residential installations. This equipment generates, uses, and can radiate radiofrequency energy, and if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee that interference will not occur in aparticular installation.If this equipment does cause harmful interference to radio or television reception, which can be deter-mined by turning the equipment off and on, the user is encouraged to try to correct the interference byone or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and the receiver.- Plug the equipment into an outlet on a circuit different from that to which the receiver is powered.- If necessary, consult the dealer or an experienced radio/T.V. technician for additional suggestions.The use of a non-shielded interface cable with the referenced device is prohibited.Changes or modifications not expressly approved by vortex Computersysteme GmbH could void theauthority to operate the equipment.
