Adcom GFR-700HD User Manual

Also see for GFR-700HD: Brochure Specification sheet Quick start guide

Contents

Adcom GFR-700HD User Manual Manual pdf 34 page image

34Chapter 3 - SetupGFR-700HD Owner’s ManualHD Scaler ConfigurationNow it’s time to enable the HD Scaler and configureit for your display and source devices.To access the HD Scaler menu:1 Press the Main button on the remote control.2 Press the Setup button.3 Use the / buttons to select INPUT CONFIG,then press the Select button.4 Use the / buttons to select HD SCALER, thenpress the Select button.5 Use the / buttons to choose from the follow-ing menu items:HDMI SWITCHEnables the HD Scaler or simply passes through theHDMI signal. Use the / buttons to select:• Scaled - Enables the HD Scaler for the selectedinput.• Video 1, Video 2 - Assigns the Video 1 or Video 2HDMI input to the selected input.• None - Disables HDMI for the selected input.IN RESSpecifies the input resolution for the HD scaler. Usethe / buttons to select:• 480i NTSC or 576i PAL.OUT RESSets the output resolution of the HD Scaler to matchyour display device. Check the specifications of yourdisplay, then use the / buttons to choose fromthe following:• Select 480i or 576i for standard NTSC or PAL inter-laced displays.• Select 480p, 576p, 720p (50/60Hz), 1080i, 1080p(50/60Hz) or VGA for high-definition and/or pro-gressive scan displays.• Select Auto to automatically detect the outputresolution of your display device.COLOR SPCSpecifies the 24-bit color space output to your dis-play device. Check the specifications of your display,then use the / buttons to select:• RGB444 (default) or YCbCr444FORMATSets the default picture format for the selected in-put. Use the / buttons to choose:• Auto - Automatically selects the best pictureformat for the current output resolution.• Full - Stretches a standard 4:3 image to fill a wi-descreen (16:9) display.• Zoom - Zooms the on-screen image proportion-ally, preserving the original aspect ratio butcropping the picture.• Squeeze - Compresses a widescreen image to a4:3 display.• NLS (Non-linear Stretch) - Stretches a 4:3 imageto 16:9, but preserves the correct aspect ratio inthe center of the picture.POSITION ADJUSTDisplays the Position Adjust menu where you canfine tune the vertical and horizontal position of thescaled image. Use the / buttons to select:• Test Patrn - Displays a test pattern to make iteasier to discern the edges of the screen.• Vert Position - Set from -31 to +31.• Horz Position - Set from -63 to +63.CABLE EQEnables cable equalization to compensate for high-frequency signal loss/dispersion when transmittinghigh-res video over long distances. Use the / but-tons to select:• Short or Long• Select Short if your HDMI cable is < 5 meters.• Select Long if your HDMI cable is > 5 meters.HDMI AUDIOSets the format of the HDMI audio signal. Leave thissetting off UNLESS you are using your display’s inte-grated audio processing, amplification and speakers.If this setting is on, you will NOT be using the GFR-700HD audio processor and amplifier. Use the /buttons to select:• PCM 2 CH, PCM/Bit, or Off• Select PCM 2CH to send a 2-channel digital audiosignal to your display device.• Select PCM/Bit to send a digital bitstream toyour display device.• Select Off to disable HDMI audio.PICTURE CONTROLSSee page 35.