Advantek Networks AWR-11N-RT User Manual

Also see for AWR-11N-RT: User guide

Advantek Networks AWR-11N-RT User Manual Manual pdf 36 page image

36Enable: Enable/Disable the port trigger.Trigger Port: This is the port used to trigger the application. It can be either a single port or arange of ports.Trigger Type: This is the protocol used to trigger the special application.Public Port: This is the port number on the WAN side that will be used to access theapplication. You may define a single port or a range of ports. You can use a comma to addmultiple ports or port ranges.Public Type: This is the protocol used for the special application.Action: Insert a new Port Trigger or update a specified Port Trigger.[Port Forward]Enable: Enable/Disable the port forward.Forward Port: This is the port used to forward the application. It can be either a single port ora range of ports.Forward Type: This is the protocol used to trigger the special application.Forward IP: This is the port number on the WAN side that will be used to access theapplication. You may define a single port or a range of ports. You can use a comma to addmultiple ports or port ranges.Action: Insert a new Port forward or update a specified Port Forward.3.2.6 Packet FilterFilters are used to deny or allow LAN computers from access the Internet. Within thelocal area network, the unit can be setup to deny Internet access to computers using theassigned IP or MAC addresses. The unit can also block users from accessing restricted website.This packet filter is used to inspect each packet for used defined content, such as anIP address but does not track the state of sessions.Click Packet Filter on Network Settings, below screen will prompt for Packet FilterSetting.All manuals and user guides at all-guides.comall-guides.com