Advantek Networks AWR-11N-RT User Manual

Also see for AWR-11N-RT: User guide

Advantek Networks AWR-11N-RT User Manual Manual pdf 8 page image

8LINK/ACT Blinking Data is being sent or received.Back Panel ConnectorsButton/Port DescriptionReset Reset configurations to default. You would use the reset button onlywhen a program error has caused your 11n AP router to hang. Press thebutton and hold for 10 seconds.WPS Click WPS button about 2-3 seconds while you are connecting a PC ofwireless adapter with WPS function (you must enable WPS’ PBCfunction).LAN(1x, 2x, 3x,4x)Ethernet RJ-45 connector, connect to PC with a RJ-45 Ethernet cable.WAN Ethernet RJ-45 connector, connect to WAN access device, such as theCable modem or ADSL modem.PWR Power connector, connect to the power adapter packaged with the AProuter.1.5 Installation Instruction1) Power off 802.11n AP Router and DSL/cable modem.2) Connect systems to the LAN ports on the Wireless Router with straight LAN cables.3) Connect the DSL or cable modem to the WAN port on the Wireless Router.4) Power on DSL or cable modem first, then connect power adapter to the power jackon the rear panel of Wireless Router and plug the power cable into an outlet.5) Check LEDs.a) Once power on Wireless Router, Power LED should be on.b) LAN LED should be on for each active LAN connection.c) The WAN LED should be on when the DSL or cable modem is connected.Warning: Only use the power adapter is provided from this package, use other poweradapter may cause hardware damage is package, use other power adapter may causeAll manuals and user guides at all-guides.com