Advantek Networks AWR-11N-RT User Manual

Also see for AWR-11N-RT: User guide

Advantek Networks AWR-11N-RT User Manual Manual pdf 59 page image

59In PBC Method (PBC-Push Button Communication), while the AP router acts as Registrar orEnrollee, and click “Start WPS Config” button, the WPS (Wi-Fi Protected Setup) will establishthe connection automatically.[WPS Config]WPS Config Method: Define the configure method by PIN number or PCB.Add Enroll PIN Code: While you define the AP acts as a Registrar and assign the configuremethod is by PIN, you can add others enrollees PIN code.3.4 InformationThe Information contains the following sections:System Information Routing Table Pack Statistics System Log3.4.1 System InformationThis page displays the current information for the device. It will display the LAN, WAN, andsystem firmware information. This page will display different information, according to WANsetting (Static IP, DHCP, or PPPoE)If your WAN connection is set up for Dynamic IP address, there will be a Release IP buttonand Renew IP button. Use Release IP to disconnect from your ISP and use Renew IP toconnect to your ISP.If your WAN connection is set up for PPPoE, there will be Connect button and Disconnectbutton. Use Disconnect to drop the PPPoE connection and use Connect to establish thePPPoE Connection.Click System Information on Information, below screen will prompt for System Information.All manuals and user guides at all-guides.com