AXIS 223M - Troubleshooting385. Reinstall the camera.If the emergency recovery procedure does not get the camera up and running again, please contact Axis supportat www.axis.com/techsup/Axis SupportIf you contact Axis support, please help us to help you solve your problems, by providing the server report, thelog file and a brief description of the problem.Server Report - go to Setup > System Options > Support Overview. The server report contains importantinformation about the server and its software, as well as a list of the current parameters.The Log file is available from Setup > System Options > Logs & Reports. The Log file records events in the unitsince the last system restart and can be a useful diagnostic tool when troubleshooting.Symptoms, Possible Causes and Remedial ActionsProblems setting the IP addressWhen using ARP/Ping. Try the installation again. The IP address must be set within two minutes after runningthe ARP command. Ensure the Ping length is set to 408.The camera is located on a differentsubnet.If the IP address intended for the camera and the IP address of your computer arelocated on different subnets, you will not be able to set the IP address. Contact yournetwork administrator to obtain an appropriate IP address.The IP address is being used by anotherdevice.Disconnect the camera from the network. Run the Ping command. (In a Command/DOSwindow, type ping and the IP address of the unit).If you receive: Reply from : bytes = 32; time = 10 ms..... - this meansthat the IP address is already in use on your network. You must obtain a new IP addressand reinstall the unit.If you see: Request timed out - this means that the IP address is available for use withyour camera. In this case, check all cabling and reinstall the unit.Possible IP address conflict withanother device on the same subnet.The static IP address in the camera is used before the DHCP server sets a a dynamicaddress. This means that if the same default static IP address is also used by anotherdevice, there may be problems accessing the camera. To avoid this, set the static IPaddress to 0.0.0.0.The camera cannot be accessed from a Web browserThe IP address has been changed byDHCP.1) Move the camera to an isolated network, or to one with no DHCP or BOOTP server.Set the IP address again, using the AXIS IP Utility (see the Installation Guide) or theARP/Ping commands.2) Access the unit and disable DHCP in the TCP/IP settings. Return the unit to the mainnetwork. The unit now has a fixed IP address that will not change.3) As an alternative to 2), if dynamic IP address via DHCP or BOOTP is required, selectthe required service and then configure IP address change notification from the net-work settings. Return the unit to the main network. The unit will now have a dynamicIP address, but will notify you if the address changes.Proxy server. If using a proxy server, try disabling the proxy setting in your browser.Other networking problems. Test the network cable and connectors by connecting it to another network device,then Ping that device from your workstation. See the instructions above.Cannot log in. When HTTPS is enabled, ensure that the correct protocol (HTTP or HTTPS) is used whenattempting to log in. You may need to manually type in http or https in the browser'saddress bar.Incorrect host name. Check that the host name and DNS server settings are correct. See the basic andadvanced TCP/IP settings.Cannot send notifications, uploads, alarms, etc, to a destination outside the local networkFirewall protection. The camera can be configured to use a SOCKS server to reach networks on the otherside of a firewall/proxy server.Your camera is accessible locally, but not externallyFirewall protection. Check the Internet firewall with your system administrator.Default routers required. Check if you need to configure the default router settings.Poor or intermittent network connection.Network switch. If using a network switch, check that the port on that device uses the same setting forthe network connection type (speed/duplex) as set in the advanced TCP/IP settings.The Auto-Negotiate setting is recommended.
