Configuration PossibilitiesAXIS 5400+ / AXIS 5600+ User’s Manual 113To enable these protocols, select Admin | Network Settings | DetailedView | TCP/IP Network for FTP, Telnet, AutoIP, DHCP and BOOTP.Remote Config is enabled via Admin | General Settings | RConfigSupport.Important:CheckingSSL/TLS StatusTo check SSL/TLS status, open the print server’s Web interface and selectAdmin | Network Settings | Detailed View | TCP/IP Network to see if theHTTPS Enabled parameter is set to Yes or No.To View a Certificate To view a Certificate, open the print server’s Web interface, select Admin| Security Settings | HTTPS and click View next to the Certificate.To Delete a Certificate To delete a Certificate, open the print server’s Web interface, select Admin| Security Settings | HTTPS and click Delete next to the Certificate.Enabling the SNMPv3 ProtocolInvoke the print server’s Web interface to enable the SNMPv3 protocol.1. Select Admin | Network Settings | Detailed View | TCP/IP Network andensure that HTTPS Enabled is set to yes to guarantee a secureconfiguration.Note: You must have a valid certificate loaded to be able to enable HTTPS.See “Enabling SSL via the Web Interface” on page 111.To ensure maximum security, it is highly recommended that you change your Administratorpassword after generating a certificate and disabling insecure protocols! This is done fromAdmin | General Settings | Change => | General | Root Password.
