AXIS 5470e User’s Guide34Verifying the Communication LinkFollow the instructions below to verify communication from the AXIS 5470e to theMainframe host via the SNA Server:1. Activate the connection you created in step 2 of the aboveSNA Server - AXIS 5470econnection procedures. The status of the connection should be “active”.2. Make sure the corresponding LU in the host is activated.3. Activate the TN3270 connection to the AXIS 5470e. The LUA should change status toSSCP.4. Send a print job from the host.Note:Important!Proceed to Management and configuration on page 47 for information on supportedmanagement and configuration tools.You can check the status of the TN3270E connection by printing a test page from the print server.This is done by pressing the test button once. Make sure the TN3270E status (St:) line for your serverconnection is defined as either:- SSCP- LU-1- LU-3If the setup fails, please refer to the troubleshooting section in the AXIS 5470e User’s Manual,supplied on the Axis Web site at http://www.axis.com
