AXIS 5470e User’s Manual Section 21: DBCS Support 225Amending Device FeaturesAfter automatic setup, it may be necessary to change the Devicefeatures and Last Code Point of the printer device. Failure to do somay cause corruption within your print data.Follow the instructions below, to set the appropriate Device featuresand Last Code Point for your chosen printer device:1. Make sure that the writer is stopped by typing ENDWTRxxxxPRT01 on the AS/400 command line, where xxxxPRT01is the printer device name. Press ENTER.2. Type VRYCFG CFGOBJ(xxxxPRT01) CFGTYPE(*DEV)STATUS(*OFF) to vary off the printer device, wherexxxxPRT01 is the printer device name. Press ENTER.3. Type CHGDEVPRT xxxxPRT01 to change the printer devicename, where xxxxPRT01 is the printer device name. Press F4.4. Under DBCS Feature (IGCFEAT) amend the Device Features andLast Code Point to the appropriate value corresponding to thecountry language.Device features and Last Code Point for Country options5. Type VRYCFG CFGOBJ(xxxxPRT01) CFGTYPE(*DEV)STATUS(*ON) on the AS/400 command line to vary on theprinter device, where xxxxPRT01 is the printer device name.Press ENTER.6. Type STRPRTWTR xxxxPRT01 to start the Writer, wherexxxxPRT01 is the printer device name. Press ENTER.7. Direct a printout to this printer device to confirm that the abovechanges have been implemented correctly.Country Device features Last Code PointKorea 2424K1 D3FEJapan 2424J1 68FEChina 2424S1 6FFE
