Axis AGS200/T250 User Manual

Axis AGS200/T250 User Manual Manual pdf 7 page image

USER MANUAL 77. Preparing moisture analyser to workDuring heating, the halogen heaters 1 warm up to very hightemperature. When drying chamber is opened avoid touching theheaters as it may cause severe burns or damage the heaters!Dryer chamber cover 3 heats up to 40°C, but perforated cover mayheat up over 60°C. Do not touch the top cover during drying as it maycause severe burns!1 2 376541 – halogen heaters2 – temperature sensor3 – chamber cover4 – dryer chamber5 – pan plate6 – single-use pan grip7 – single-use pa8 – distance stake9 – regulated legs10 – level81091. Take all contents out of a package: the moisture analyser and packed separately: thetin pan shield, single use pans, the pan handle and the pan support. It isrecommended to keep the original moisture analyzer package in order to transportthe moisture analyzer safely in future2. Place the moisture analyzer on a stable ground not affected by mechanical vibrationsand airflows.3. Level the moisture analyzer with rotating legs 9 so that the air bubble in water-level10 at the back of the moisture analyzer is in the middle and the moisture analyserrests on all four legs.4. Open the dryer chamber with the handle at the front. Put the pan shield 4 on threedistance sleeves 8. Gently insert the pan support 5 into the mechanism hole.5. Place a single use pan 7 on the pan handle 6 and put the pan on the pan support(the handle should rest on the pan shield so that it does not touch the pan or the pansupport).6. Close the drying chamber cover 3 and plug the device to the mains (230V).