Axis M3004-V User Manual

Also see for M3004-V: Technical specifications User manual Installation guide Installation guide

AXIS M3004-V Network CameraSystem OptionsRTP/H.264The RTP port range and multicast settings are configured under System Options > Network > RTP.The RTP port range defines the range of ports from which the video ports are automatically selected. For multicast streams, onlycertain IP addresses and port numbers should be used.Select Always Multicast Video to start multicast streaming without opening an RTSP session.BonjourThe Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operatingsystems and clients that support this protocol.Bonjour can be disabled under System Options > Network > Bonjour.StorageSD CardNOTICENOTICENOTICETo prevent corruption of recordings, the SD card should always be unmounted before it is ejected.The Axis product supports SD cards with the following file systems:• ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To accessdata stored on the card from the Windows operating system, a third-party ext4 driver or application is required.• vFAT — most SD cards are pre-formatted with vFAT when purchased.If required, the SD card can be re-formatted to the desired file system. To format the SD card:1. Insert the SD card in the SD card slot.2. Go to System Options > Storage and click SD Card.3. Click Format and select the desired file system.NoteDuring formatting any previous data stored on the disk will be lost.Mounting is done automatically when the card is inserted or when the product is started. A manual mount is only required if thecard has been unmounted and not ejected and re-inserted.To unmount the SD card:1. Go to System Options > Storage and click SD Card.2. Click Unmount.3. The card can now be removed.The SD card is managed on the System Options > Storage page. Click SD Card to open Storage Management.If the card’s status shows as failed, click Check disk to see if the problem can be found and then try Repair. This option is onlyavailable for SD cards with ext4. For SD cards with vFAT, use a card reader or computer to troubleshoot the card.To avoid filling the card, it is recommended to remove recordings continuously. Under Recording Settings, select Remove recordingsolder than and select the number of days or weeks.To stop writing to the card and protect recordings from being removed, select Lock under Recording Settings.41