Axis M7010 User Manual

Also see for M7010: Installation guide User manual

AXIS M7010Hardware OverviewHardware Overview7 8 91 2 3 4 5 610 1112 13 14 151. Video input connectors2. LED indicators3. Group 1 (4 video input connectors)4. Group 25. Group 36. Group 47. Power connector8. SD memory card slot (micro SD)9. RS-485/RS-422 connector10. Control button11. Network connector (P0E)ConnectorsFor technical specifications, seepage 44.Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).NOTICEDue to local regulations or the environmental and electrical conditions in which the product is to be used, a shieldednetwork cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similarshall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. Seefor regulatory requirements.SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage.NOTICETo prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > SystemOptions > Storage > SD Card and click Unmount.Control button - The control button is used for:• Connecting to an AXIS Video Hosting System service. Seepage 32. To connect, press and hold the button for about1 second until the Status LED flashes green.• Connecting to AXIS Internet Dynamic DNS Service. Seepage 33. To connect, press and hold the button forabout 3 seconds.4