Section 3: Setup for NetWare18 Axis NPS 550 User’s ManualLink a PrintQueue to thePrint ServerThe next step is to link a print queue to the print server:1. Start PCONSOLE according to steps 1-3 on the previous page.2. Select Print Queue Information (3.xx) or Print Queues (4.xx). If youplan to use an existing queue, then skip to step 5.3. Press to add a new queue.4. Type a queue name, and press . (see note below)5. Select the queue that you want the NPS 550 to service. The PrintQueue Information menu appears.6. Select Queue Servers (3.xx) or Print Servers (4.xx).7. Press to display the Queue Server Candidates list.8. Select AXIS.9. Press repeatedly to return to the main menu.Repeat this procedure for every queue you want the NPS 550 to service.The NPS 550 supports up to 96 print queues, defined on up to 16 fileservers.Note: Assuming that you have the default Logical Printer settings, output fromthe print queue will be directed to the LPT1 output of the NPS 550. Ifyou want to print to LPT2, the queue name must end with ‘!2’. Whenprinting to NPS 550 serial port, the queue name must end with ‘!3’.Example: The Print Queue is called ‘DESKTOP!2’. Printouts will be directed toLPT2 (with the default logical printer settings).Note that the number after the exclamation mark refers to the logicalprinter number rather than the port number. You can bypass any queuename restrictions by using one of the alternative print server modesdescribed on the following pages.
