Axis OfficeBasic USB User Manual

Also see for OfficeBasic Parallel: Installation guide

Contents

Axis OfficeBasic USB User Manual Manual pdf 53 page image

Updating the FirmwareAXIS OfficeBasic USB & AXIS OfficeBasic Parallel User’s Manual 53Section 8 Updating the FirmwareUpgrading the FirmwareYou can upgrade the print server’s firmware using one of the followingmethods:• From the print server’s internal Web pages (TCP/IP)• FTP (TCP/IP)Upgrading from thePrint Server’s InternalWeb PagesFollow these instructions to upgrade the firmware of your print serverfrom its internal Web pages (flash loading over the Web):1. Open your Web browser, enter the IP address of your print server andpress Enter. (See “Using a Web Browser for Print Server Management” onpage 42 for detailed instructions on accessing your Axis print server onthe Web).2. From the Admin mode, click the Firmware Upgrade button. From here youcan upgrade your print server with the latest available firmware.Upgrading over theNetwork using FTPTo upgrade over the network using FTP you will need a file with the newprint server firmware. The name of this file is in the formproduct_version.bin.Ensure that FTP Enabled is set to yes. To check this parameter, browse tothe print server and select Admin | Network Settings | Detailed View |TCP/IP Network.You must assign an IP address to the print server before you can use thisupgrading method. Follow the procedures below to upgrade the printserver:Caution!FTP is a standard protocol to move files in a TCP/IP network and it is thesame procedure to load new program files into a print server. Theprocedure to upgrade the print server software is as follows:Be careful not to interrupt the file transfer. If the transfer is interrupted, theprint server may have to be re-initialized by your dealer.