Axis OfficeBasic USB Wireless User Manual
Also see for OfficeBasic USB Wireless: SpecificationUser manualInstallation guideUser manualUser manual
                                                     | |
Contents
| 
Print Server ManagementAXIS OfficeBasic USB Wireless 39Print server management using the Reset buttonThe reset button can be used for several operations, see Print Server Setup, onpage 8 for the physical location of the Reset button.Reset the Print Server:1. Verify that the DIP switch is on “Nor.”2. Press the reset button once.Print a Test Page:Print a Test Page in“Normal Mode”1. Verify that the DIP switch is on “Nor.”2. Hold down the reset button for 5 seconds. The test page will be printed onthe connected printer.Print a Test Page in“Diag” Mode1. Verify that the DIP switch is on “Diag.”2. Hold down the reset button for 5 seconds. The test page will be printed onthe connected printer.WARNING! This will restart the print server and stop all on-going and pending printjobs!The test page printed in “Normal” mode displays information about the printserver’s:• Device Name (print server name)• Firmware version• MAC address• SSID• Channel• WEP enabled or disabled• IP address• Subnet Mask• Default Router• AppleTalk Port NameThe test page printed in “Diag” mode displays information about all availableAccess Points within your wireless network, including SSID, network type,serial number, channel and signal. |
Related manuals for Axis OfficeBasic USB Wireless
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine