|
Appendix 2: Enabling WEP in the AXIS OfficeBasic USB WirelessAXIS OfficeBasic USB Wireless 45Appendix 2: Enabling WEP in the AXISOfficeBasic USB WirelessIf your WLAN is Infrastructure-based (with an Access Point) and uses WEPencryption, follow these instructions to connect and install the AXISOfficeBasic USB Wireless print server:1. Switch the print server’s DIP switch to DIAG mode.2. Create a new profile or use an existing one on your laptop to connect to theprint server, as described in Appendix 1: Print Server Setup in Ad Hoc Mode,on page 43.3. Install and run AXIS OBW Wizard.4. From the Select A Print Server screen, select your print server and click Next.5. On the Change Settings screen select Yes and click Next.6. On the Basic Wireless Settings screen keep Infrastructure (default) ascommunication type.7. Keep as default SSID or change it to match your WLAN settings.8. Keep Auto as default Data transmit rate or change it to match your WLANsettings. Click Next.9. On Security and WEP Encryption Settings screen, check Enable WEPEncryption.10. Choose Type (64-bit or 128-bit), Key Format (Alphanumeric or Hexadecimal)and enter an Encryption Key to match your WLAN settings. Click Next.11. Click Next on the 802.1X Settings screen if you do not use any kind ofauthentication. If MD5 is selected, you must enter the same Login Name andPassword as defined on the Radius server.Note: A Radius server is used for remote user authentication and accounting.Its primary use is for Internet Service Providers, though it mayas well be used on any network that needs a centralized authentication and/oraccounting service for its workstations.12. In TCP/IP Settings, specify a fixed or dynamic IP address, then click Next. Afixed IP address is highly recommended; select Specify an IP address and fillthe settings to match your WLAN settings. Click Next.13. Click Next again to save your settings.14. Click Cancel on the Select A Printer screen (as you are not going to installa printer).15. Switch the print server’s DIP switch back to NORMAL.16. From a workstation on your LAN, open a Web browser, enter the IP addressof your print server to verify the AP connection in the WEP encrypted WLANand press Enter. The print server’s internal web pages will appear.For detailed information about WEP settings, see Setup Menu, on page 33.
|
