Axis P3214-V User Manual

Also see for AXIS P1425-LE Mk II: User manual Installation guide Installation guide Installation guide User manual

AXIS P3214-V Network CameraEvents- Day/Night Mode – Trigger the rule when the product switches between day mode (IR cut filter on) and nightmode (IR cut filter off). This can for example be used to control an external infrared (IR) light connectedto an output port.- Live Stream Accessed – Trigger the rule when any stream is accessed and during edge storage playback.This can for example be used to send notifications.- Tampering – Trigger the rule when tampering is detected. See Camera Tampering on page 29.• Hardware- Network – Trigger the rule if network connection is lost or restored. This can for example be used to startrecording to the SD card.- Temperature – Trigger the rule if the temperature falls outside or inside the operating range of the product. Thiscan for example be used to send maintenance notifications.• Input Signal- Manual Trigger – Trigger the rule using the Manual Trigger button in the Live View page. See Controls onthe Live View Page on page 11. This can for example be used to validate actions during product installationand configuration.- Virtual Inputs – can be used by a VMS (Video Management System) to trigger actions. Virtual inputs can, forexample, be connected to buttons in the VMS user interface.• PTZ- Moving – Trigger the rule when the camera view moves due to a PTZ operation. This can for example be usedas an additional condition to prevent an action rule triggered by motion detection to record video while thecamera view moves due to a PTZ operation.- Preset Reached – Trigger the rule when the camera stops at a preset position. This can be for example be usedwith the Send Images action to upload images from the preset position.• Storage- Disruption – Trigger the rule if storage problems are detected, for example if the storage device is unavailable,removed, full, locked or if other read or write problems occur. This can for example be used to send maintenancenotifications.- Recording – Triggers the rule when the Axis product records to the storage device. The recording status triggercan be used to notify the operator, for example by flashing LED lights, if the product has started or stopped torecord to the storage device. Note that, this trigger can be used only for edge storage recording status.• System- System Ready – Trigger the rule when the product has been started and all services are running. This can forexample be used to send a notification when the product restarts.• Time- Recurrence – Trigger the rule periodically. See Set Up Recurrences on page 41. This can for example be used toupload an image every 5 minutes.- Use Schedule – Trigger the rule according to the selected schedule. See Create Schedules on page 40.ActionsAvailable actions include:• Day/Night Vision Mode – Set day mode (IR cut filter on) or night mode (IR cut filter off).• Overlay Text – Display an overlay text. See Use Overlay Text in an Action Rule on page 23.38