AXIS P5522 PTZ Dome Network CameraPTZ (Pan Tilt Zoom)To add a guard tour:1. Go to PTZ > Guard Tour and click Add.2. Enter a descriptive name.3. Specify the pause length between runs.4. Select an available preset position and click Apply.5. Specify the Move speed.6. Specify the View Time in seconds or minutes.7. Specify the View order or select the Random view order check box option.8. Click Save.To modify or remove guard tours, go to PTZ > Guard Tour, select the guard tour in the Guard Tour List and click Modify/Remove.For more information see the online help .NoteThe pause between guard tour runs must be set to at least 10 minutes.OSDI ZonesOn-Screen Direction Indicator (OSDI) zones can be included in the overlay text (see Overlay, on page 18) to aid the user to navigatethe Axis product. Each OSDI zone is set up with coordinates and a descriptive name.OSDI zones are set up under PTZ > OSDI Zones. The Axis product uses the coordinates of the center of the view to set the lowerleft and upper right zone areas. First navigate to where you would like the lowermost left point of the OSDI zone to be located.Click Get to set the coordinates. Proceed to where the upper right point of zone should be located and click Get. Give the zone adescriptive name and click OK.To include the name of the OSDI zone in the overlay text, go to Video & Audio < Video Stream < Overlay Settings. Check theInclude text box and enter the modifier #L in the field. For more information about modifiers, see File Naming & Date/Time Formatsin the online help .AdvancedLimitsDefine the pan, tilt, zoom and focus limits for the Axis product. Movements to the left and right, up and down, can be restricted tonarrow the area under surveillance.Configure the near focus limit to avoid focusing on objects too close to the camera lens.Move speed sets the speed of the camera’s pan and tilt movements. The default setting is maximum speed.When using a joystick (or emulating one with the mouse) the Enable proportional speed setting can be used to reduce the maximumpan/tilt movement speed, i.e. the speed the camera view moves at when the joystick is pushed all the way out in any direction. This isuseful then the view is zoomed in on an object.When Enable Auto-flip is selected, the Axis product will simulate continuous pan movement in the same direction, i.e. the camerawill pan the full 360 degrees, even though there is a mechanical stop at ±180 degrees.When Enable movement prediction is selected, the Axis product will attempt to predict the new position in the pan movement, aftercompensating for the slight delay while the camera changes direction after an auto-flip. This is useful for tracking moving objects orpersons when using the joystick or emulated joystick mode.25