Axis Q7436 User Manual

Also see for Q7436: Installation guide Installation guide User manual

Axis Q7436 User Manual Manual pdf 35 page image

AXIS Q7436 Video Encoder BladeEventsTo add additional criteria, select the Additional conditions option and add additional triggers. To prevent an action from beingtriggered repeatedly, a Wait at least time can be set. Enter the time in hours, minutes and seconds, during which the triggershould be ignored before the action rule can be activated again.The recording Duration of some actions can be set to include time immediately before and after the event. Select Pre-trigger timeand/or Post-trigger time and enter the number of seconds. When While the rule is active is enabled and the action is triggeredagain during the post-trigger time, the recording time will be extended with another post-trigger time period.For more information, see the online help .Fallback ActionA fallback action is started if the primary action cannot be started, for example if connection to a recipient cannot be established.Fallback actions are typically used to send email notifications on failed actions or to upload images to a secondary recipient.RecipientsRecipients receive media files and notification messages. The following recipients are available:Recipient Use with actionEmail1 Send ImagesSend NotificationSend Video ClipFTP Send ImagesSend Video ClipHTTP Send ImagesSend NotificationSend Video ClipNetwork Share2 Send ImagesSend Video ClipTCP Send Notification1. Some email providers have security filters that prevent users from receiving or viewing large amount of attachments, from receiving scheduledemails and similar. Check the email provider’s security policy to avoid delivery problems and locked email accounts.2. A network share can also be used as a storage device for recorded video. Go System Options > Storage to configure a network share beforesetting up a continuous recording or an action rule to record video. See Storage, on page 46 for more information about storage devices.To add a recipient:1. Go to Events > Recipients and click Add.2. Enter a descriptive name.3. Select a recipient Type.4. Enter the information needed for the recipient type.5. Click Test to test the connection to the recipient.6. Click OK.35