2. Access the switch point TEACH mode and TEACH the sensor.Action ResultNavigate: MENU > D_OUT > TchSPt"TchSPt Teaching" displays while thesensor is being taught.TEACH AcceptedThe new value is shown on the second lineof the display and flashes before it is savedand the sensor returns to "D_OUT TchSPt".TEACH Not Accepted"FAIL" and a warning message display, andthe sensor returns to "D_OUT TchSPt".Remote Input Instructions1. Verify the sensor is in Switch mode.2. Access the TEACH mode.Action ResultSingle-pulse the remote input. T "RMT TCH" and the current measurementvalue display.3. Present the target.Action ResultPresent the target. "RMT TCH" and the target's measurementvalue display.4. TEACH the sensor.Action ResultFive-pulse the remote input.T TTTTTTTT"TchSPt Teaching" displays while thesensor is being taught.TEACH AcceptedThe new value displays on the second lineof the display, flashes, and the sensorreturns to Run mode.TEACH Not Accepted"FAIL" flashes, the sensor returns to step 3,and "RMT TCH" displays.3.6.6 Adjust Switch PointThe AdjSPt option manually adjusts the value of the switch point threshold for the discrete output when the sensor is inSwitch mode. The value is adjustable within the sensor's range. This menu is not available when the sensor is in Window,Alarm, or Health mode.Navigate: MENU > D_OUT > AdjSPtRemote Input: Not availableDefault: 50 mm3.6.7 ModeThe Mode option sets the output to the desired mode.Navigate: MENU > D_OUT > ModeRemote Input: AvailableDefault: Wnd modeThe following table describes the sensor modes.L-GAGE® LTF Time of Flight Laser Distance Sensor22 www.bannerengineering.com - Tel: +1.763.544.3164