7-1Start up of the Adjustment Mode5975967 BARCODATA 9200 2201987Adjustment ModeAll source parameters, picture tuning and geometry are made while in the 'Adjustment Mode'. Press the ADJUST or ENTER key to enter the 'Adjustment mode'.You are now in the 'Adjustment Mode'. The control disc (RCU) or '+ or '-' keys (local keypad)are used to make menu selections and also for adjustments. The ENTER and EXIT keys areused to move forward and backward through the menu structure. The ADJUST key canbe used to terminate the adjustment mode while any path selection menu is displayed.ADJUSTMENT MODESelect a path from below :RANDOM ACCESSINSTALLATIONSERVICESource 01Select with orthen to return.Random Access - Random Access should be selected to set upa new source.Service - Service should be selected if the user intends to changegeneral settings such as password, language, address, etc.or someservice actions as reset lamp run time, panel adjustments, etc. or getset-up information.There are 3 possible paths to follow once in the Adjustment Mode.They are :Installation - Installation should be selected if a new input moduleis installed or a new source is connected to an existing input module.Also when the projector is relocated in a new configuration.Some items in the Adjustment mode are password protected. While selecting such an item,the projector asks to enter your password (Password protection is only available when thepassword strap on the controller module is ON, see 'Change password' in chapter 10 :'Service mode'.Your password contains 4 digits.Enter the digits with the numeric keys.Example : 2 3 1 9The first digit position is highlighted. Enter with the numeric keys. The highlighted squarejumps to the next position. Continue until all 4 digits are filled in.ENTER PASSWORD----Use numeric keys to returnPASSWORDErrorInvalid password to returnWhen your password is correct, you gain access to the selected item.When your password is wrong. The error message "Invalid password" is displayed on thescreen. Press EXIT to continue and to return to the Service menu.Factory programmed password : 0 0 0 0Once the password is correctly entered, all other password protected items are accessiblewithout re-entering your password.When re-entering the Adjustment mode, it will be nessary to enter your password again whenselecting a password protected item.START UP OF THE ADJUSTMENT MODE
