5. Getting StartedLed # / Led Color Green RedLed 2 Not used Hardware errorLed 3 IR acknowledgement Standby Status5.5 Switching OnHow to Switch On the Projector?1. Press the Power Switch on the Left Front of the Projector to switch on the projector. (image 5-4)The projector starts up in standby mode and Led 3 will light up red.I0Image 5-4Power SwitchWhen automatic startup is set to ’On’, the projector will immediately start with image projection (see "Auto-matic Startup", page 209).How to Start Image Projection?1. Press the STANDBY key (or the Source Selection Shortcut Digit) on the RCU or on the Local Keypad. (image 5-5)Note: When automatic startup is set to ’On’, the projector will immediately start with image projection when swithing the projector’On’ (see "Automatic Startup", page 209).The projector will start up, following message will be displayed, according to the used Dynacolor™ settings, the message displaytime can vary between 5 to 30 seconds. (image 5-6)The ’Please Wait’ message will disappear and the identification box will be displayed together with the selected source. After 2seconds the identification box will disappear. (image 5-7)F1F2 F3 F4F5ADJ EXITENTERPAUSEPHASETEXTSHARPNTINTCOLORBRIGHTNCONTRTREBLE BALANCEBASS VOL9 07 85 63 41 2SOURCELENSImage 5-5Standby key on the RCU or Local KeypadImage 5-636 R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007
