7. Image Menu7.5.6 Blanking – SoftedgeWhat can be done with Blanking – Softedge?When setting up a soft edge (see Electronic Softedge), these settings are by default applied on all sources (source files). With theBlanking – Softedge toggle it is possible to disable the Blanking – Softedge settings for the current source file.Blanking – Soft Edge is default set to On.How to change the Blanking – Softedge Setting?1. Push the cursor key ↑ or ↓ to highlight Blanking – Softedge and press ENTER to select.The Blanking – Softedge Setting will be displayed. (image 7-39)2. Use the cursor key ↑ or ↓ to select On or Off.3. Press ENTER to confirm.Image 7-397.6 SettingsOverview• Introduction• Contrast• Brightness• Gamma• Phase• Sharpness7.6.1 IntroductionIntroductionWithin the Settings menu it is possible to adjust the general image settings.7.6.2 ContrastIt is advised not to use the Contrast Adjustment in a multi channel application.How to use the Contrast Adjustment?1. Push the cursor key ↑ or ↓ to highlight Contrast... and press ENTER to select. (image 7-40)Note: The Contrast value is by default set to 100.The Contrast Sliderbox will be displayed. (image 7-41)62 R5976870 BARCOREALITY SIM 5PLUS/SIM 5R 04/04/2007
