8-2Random Access Adjustment Mode5975848A BARCOREALITY 8200LC 271197Select with orthen to return.Select with orthen to return.Select with orthen to return.Highlight File Service by pushing the control disk up or down and pressENTER to select. The File service menu will be displayed.ENTER displays the File Service menu;EXIT returns to the Path selection menu.ADJUST returns to operational mode.The following file manupulations are possible :- Load : installation of a file for a new source.- Edit : editing a loaded file to the source specs.- Rename : renaming a file.- Copy : copying a file to a new file.- Delete : deleting an existing file.- Options : way of sorting the files.Load FilePush the control disk up or down to select LOAD and press ENTER todisplay the Load menu.The Load menu displays the corresponding files depending on theinstalled filter.This filter can be "Fit" or "All". To change the filter, push the control diskto the right to select "filter list" (filter list will be hightlighted) and pressENTER to toggle the annotation between brackets."All" : all files that can be loaded will be displayed."Fit" : only the best fitting files will be displayed (with a distinction of ±2 lines and line duration distinction of ± 300 ns, if noting is found wihtinthis small area, the projector continues searching until it finds something.)Push the control disk up or down to select the best fitting file and pressENTER to select.When scrolling through the files, the image will be adapted according tothe settings of the selected file (on line adaptation). When the best fittingimage is displayed, press ENTER to select this file. A confirm Load filemenu will be displayed with the newly created file and the one on whichthe new file is based on.Press ENTER to confirm your new creations or EXIT to return to the loadfile menu.If the displayed image is not correct, go to the Edit menu, select the activefile and change the File settings.During a load file, the actual active file is displayed next to the indication'Active file'.Edit FileThe Edit file menu makes it possible to change the settings of the fileaccording to the real settings of the connected source. Consult thesource specification before entering the data.To start up the EDIT menu, push the control disk up or down to select EDITin the FILE menu and press ENTER.Select the file which must be edited (mostly the active file) and pressENTER.The Edit file adaptation menu will be displayed.RANDOM ACCESSADJUSTMENT MODEFILE SERVICEPICTURE TUNINGGEOMETRYFILE SERVICELOADE D I TRENAMECOPYDELETEOPTIONSSelect with orthen to return.FILE SERVICELOADE D I TRENAMECOPYLOAD FILEFILTER LIST [All]Filename Src Resolution-----------------------------------------------------ntsc .s01 1 675x240intsc .c01 1 675x240intsc_2 .s01 1 675x240i-----------------------------------------------------Active file : ntsc.c50Select with or , to accept to return.CONFIRMLOAD FILECreate filentsc.c02based on filentsc.s01? to confirm to returnFILE SERVICELOADEDITRENAMECOPYEDIT FILEFilename Src Resolution-----------------------------------------------------ntsc .s01 1 675x240intsc .c01 1 675x240intsc_2 .s01 1 675x240i-----------------------------------------------------Active file : ntsc.c50Select with or , to accept to return.
