R5906150 /02 XDL12412.1 Opening the front and rear cover doorsThis procedure assumes that the lens is removed and that the hoses are disconnected from theprojector. This procedure is applicable for all four cover doors.To access the thumbscrews of the top cover it is sufficient to open de cover doors a fewcentimeters. In this case it's not needed to remove the lens and to disconnect the hoses.Required toolsNo tools required.Open cover doors1. Unlatch (reference 1 Image 12-1) and pivot the plastic cover door.1 1Image 12-112.2 Removal of the top coverThe illustrations in this procedure are based on the top-left cover. Nevertheless, the sameprocedure is applicable for the top-right cover as well.Required toolsFlat screwdriver 7 mmHow to remove a top cover?1. Unlatch and pivot the front and rear plastic cover doors a few centimeters. This to gain access to the twothumbscrews of the top cover. See procedure “Opening the front and rear cover doors”, page 124.2. Loosen the two captive thumbscrews of the top cover (reference 2 Image 12-2).Removal and installation of the projector covers
