R5906150 /02 XDL 53Required tools• Open end wrench 17 mm• Open end wrench 24 mmHow to align1. Place the projector in the desired location. Take into account the zoom range of the used lens and the size ofthe screen.2. Project one of the internal patterns on the screen.3. Turn the adjustable feet in or out until the projected pattern has a perfect rectangle shape and is leveled. To doso, proceed as follows• Loosen the long nut (reference 1 Image 5-3) on the threaded rod of the four projector feet. Use a 24 mmopen end wrench.• Adjust the height of the four legs to level the projector. Use a 17 mm open end wrench to adjust the heightas illustrated (reference 2 Image 5-3).• Secure the leg height by tightening the long nuts (reference 1 Image 5-3) of each projector foot against theprojector chassis.112Image 5-3: Level alignmentWhen this is achieved, the projector is set horizontal and vertical at right angles to the screen.SCREENSCREENImage 5-4: Angle adjustment5.3 Connecting the hoses with projector andchillersWhat has to be done?The cooling circuit of the chiller(s) has to be connected with the cooling circuit of the projector. For that hosesare needed. The length of the hoses depend on the position of the chillers in relation to the projector. Themaximum length is 10 meter!Physical Installation
