R5906150 /02 XDL 61L1L1L1L1 L2L2L2L2 L3L3L3 NN PEPEPEPEPE21Image 5-154. Secure the AC power supply cord by fastening the cable gland (reference 2 Image 5-15).5. Install the cover of the mains compartment.5.9 Power loop through to the projector electronicsThis procedure explains how to provide the projector electronics with power in case no UPS unit isused. Note that the projector is by default configured for use without UPS. So, the short power linkcable is already installed.Required toolsNo tools required.Required partsShort power link cable with plug type C13/C14How to loop through the power?1. Plug in the short power cable (reference 1 Image 5-16) which was delivered with the projector.Warning: Always use the Barco short power cable which is delivered with the projector.2. Secure both plugs of the short cable with a fixation spring (reference 2 Image 5-16). Handle as follow:• Squeeze the fixation spring together.• Slide the fixation spring on the fixation pins (reference 3 Image 5-16) while squeezing together and push itagainst the power plug.• Release the fixation spring.Physical Installation
