Barco XDL Series Installation Manual

Contents

Barco XDL Series Installation Manual Manual pdf 17 page image

R5906150 /02 XDL 17Electric related safety labelsLabel image Label description Label locationDéconnecter l’alimentation des bornes du réseau et déconnecter le câblede la prise UPS pour la coupure de toute l’alimentation de l’appareil.ATTENTION : COURANT DE FUITE ÉLEVÉ RACCORDEMENT À LATERRE INDISPENSABLE AVANT LE RACCORDEMENT AU RÉSEAUVOIR LA NOTICE D’INSTALLATION AVANT DE RACCORDER AU RÉSEAUDisconnect the power to the unit mains terminals and unplugpower cord at UPS inlet for removal of all power from the unit.WARNING : HIGH LEAKAGE CURRENT EARTH CONNECTIONESSENTIAL BEFORE CONNECTING SUPPLYSEE INSTALLATION INSTRUCTIONS BEFORE CONNECTING TO THE SUPPLYW2U1U2V1V2W1200-240V3W+PE XXA50-60 HzPENL1L2L3U1V1W1W2U2V2200-240V/346-415V3W+N+PE XXA50-60 HzPENL1L2L3R8755937Disconnect the power to the unit mainsterminals and unplug power cord at UPS inletfor removal of all power from the unit.WARNING : HIGH LEAKAGE CURRENTEARTH CONNECTION ESSENTIAL BEFORECONNECTING SUPPLY SEE INSTALLATIONINSTRUCTIONS BEFORE CONNECTING TOTHE SUPPLY.Déconnecter l’alimentation des bornes duréseau et déconnecter le câble de la prise UPSpour la coupure de toute l’alimentation del’appareil. ATTENTION : COURANT DE FUITEÉLEVÉ RACCORDEMENT À LA TERREINDISPENSABLE AVANT LERACCORDEMENT AU RÉSEAU VOIR LANOTICE D’INSTALLATION AVANT DERACCORDER AU RÉSEAU.断开放映机主电源端的电源并从UPS电源接入插座上拔下电源线. 警告：大漏，电流在接通电源之前必须先接地. 在与电源连接前请查看安装说明书.(located behind cover)UPS INLET : 200-240V6A max 50-60HzUPS OUTLET : ONLY FORCONNECTION TO UPS INLETWARNING :Disconnect the power to themains terminals and unplug powercord at UPS inlet for removalof all power from the unit.ATTENTION :Eteindre et déconnecter le câbledans la prise UPS pour la coupurede toute l'alimentation de l'appareil.UPS INLET : 200-240V 6A max. 50-60Hz. UPSOUTLET : ONLY FOR CONNECTION TO UPSINLETWARNING : Disconnect the power to the mainsterminals and unplug power cord at UPS inletfor removal of all power from the unit.ATTENTION : Eteindre et déconnecter le câbledans la prise UPS pour la coupure de toutel'alimentation de l'appareilUPS电源输入插座：200-240V 最大电流 6A 50-60Hz. UPS 输出插座：仅用于连接 UPS电源输入插座. 警告断开放映机主电源端的电源并从UPS电源接入插座上拔下电源线，切断放映机的所有电源.1.5 High Brightness precautions: Hazard Distance(HD)HDHazard Distance (HD) is the distance measured from the projection lens at which the intensity or theenergy per surface unit becomes lower than the applicable exposure limit on the cornea or on theskin. The light beam is considered (to be) unsafe for exposure if the distance from a person to thelight source is less than the HD.Restriction Zone (RZ) based on the HDThe HD depends on the amount of lumens produced by the projector and the type of lens installed. See nextchapter“HD in function of modifying optics”, page 21.To protect untrained end users (as cinema visitors, spectators) the installation shall comply with the followinginstallation requirements: Operators shall control access to the beam within the hazard distance or install theproduct at the height that will prevent spectators' eyes from being in the hazard distance. Radiation levels inexcess of the limits will not be permitted at any point less than 2.0 meter (SH) above any surface upon whichSafety