Barco iD R600 Owner's Manual

Also see for iD R600: Owner's manual

Contents

Barco iD R600 Owner's Manual Manual pdf 28 page image

4. Setup13 DIGI ZOOM allows a digital Zoom of a part of the image14 FREEZ press to freeze the projected image.15 PIP allows to activate the PICTURE IN PICTURE mode16 ENTER to confirm an adjustment or selection in the MENU.On the local keypad the ENTER button additionally accesses the PIP window resize function17 Cursor keys Cursor Keys on RCU or on the local keypad : to make menu selections or to access thetoolbar.18 BACK to leave the selected menu or item (go upwards to previous menu).19 EFFECTS not yet implemented20 PIP ADJUST allows to select a PiP window and change its configuration on screen21 RC operating indication lights up when a button on the remote control is pressed. (This is a visual indicator tocheck the operation of the remote control)22 IR receiver IR receiverTable 4-2ordernumber RCU: R763794K4.3 Switching onHow to switch on.1. Press the power switch to switch on the projector.- When ’0’ is pushed in, the projector is switched off.- When ’1’ is pushed in, the projector is switched onThe projector starts in standby mode, LED3 is red.Starting image projection.1. Press Standby key once on the local keypad or on the remote control. (image 4-3)9 0EN T ERM EN U B A C KD I G IZ O O MPH A SEPA U SE PI PL O G OImage 4-3It may take about 60 seconds before image projection, i.e. no projection until the completion of several oper-ations (software initialization,...).If the Security mode is enabled, a textbox will be displayed for PIN code entry, see Security setting in theInstallation menu24 R5976837 BARCO ID R600/R600+ 21/09/2006