4. Setup4.5 Projector addressWhat can be done ?The projector is shipped with projector address set to ”0”In some cases the projector address must be changed, for example if an unique RCU is used to control 2 or more projectors (inde-pendently).In the OSD menu Projector Address, the following addresses can be programmed :• Projector address: address defined by the user, may be from 0 to 2550-9 is used for RCU communication, 0–255 being used for RS232 serial communication.• Common address : address may be 0 or 1How to change the projector’s RC5 address ?1. Press MENU to activate the Tool bar2. Press → to select the Installation3. Press ↓ to Pull down the Installation menu4. Use ↑ or ↓ to select Projector address (image 4-5)5. Press ENTERA dialog box appears on the screen. (image 4-6, image 4-7)Image 4-5Image 4-6 Image 4-7Entering the new projector address ?1. Enter the new projector address with the digit keys on the RCU, the local keypad or the cursor keys.This address must be between 0 and 255.How to change the common RC5 address ?1. Press MENU to activate the Tool bar2. Press → to select the Installation3. Press ↓ to Pull down the Installation menu4. Use ↑ or ↓ to select Projector address26 R5976837 BARCO ID R600/R600+ 21/09/2006
