Baroness SP05 Service Manual

Also see for SP05: Owner's operating manual Assembly and installation manual Assembly and installation manual Owner's operating manual

Baroness SP05 Service Manual Manual pdf 123 page image

r4ma8y-004Finishing brush section_004Removal and installation of eachsectionRakeRemoving the rakePark the machine on a level surface andlower the rake.Unhook the cross-link chains (1) from therake holding arm (2).Loosen the nuts (4) on the rake fulcrumpipe (3) and remove washers A (5) and B(6).65132AA4376lim4q-001Removing the rake_0011.2.3.1 Cross-link chains2 Rake holding arm3 Rake fulcrum pipe4 Nuts5 Washer A6 Washer B7 Fulcrum swing fittingInstallation of the rakeInstall the rake by reversing the steps for itsremoval.CautionRefer to the list of tightening torques. We do notaccept responsibility for problems resulting fromimproper or excessive tightening.ImportantWhen tightening the nuts, make sure that thereis a little play between the rake fulcrum pipeand the fulcrum swing fitting. (See “Removingthe rake_001.”)Front blade sectionFor details on how to remove and install thefront blade section, refer to the procedure forhandling it.Sand cultivator sectionFor details on how to remove and install thecultivator, refer to the procedure for handling it.Finishing brush sectionFor details on how to remove and install thefinishing brush section, refer to the procedure forhandling it.Cargo box sectionFor details on how to remove and install thecargo box, refer to the procedure for handling it.Inspection and repair of each sectionRakeExcessive use or damage to the rake causedduring its operation or while the machine istraveling may result in tire tracks on the groundafter the work has been completed. Perform thefollowing inspection and replace or repair parts ifnecessary.Work machine and mower unitWork machine and mower unitPage 8-5Removal and installation of each section