Physical InterfaceBasler pioneer 1079.5 Input PowerInput power must be supplied to the camera’s 12-pin connector via the power and I/O cable.Nominal input voltage is +12 VDC, however, the camera will operate properly on any input voltagebetween +12.0 VDC and +24.0 VDC with less than one percent ripple. Power consumption is asshown in the specification tables in Section 1 of this manual..For more information about the 12-pin connector and the I/O cable see Section 9.2 on page 102and Section 9.3 on page 104.9.6 Ethernet GigE Device InformationThe camera uses a standard Ethernet GigE transceiver. The transceiver is fully 100/1000 Base-T802.3 compliant.Voltage Outside of Specified Range Can Damage the CameraIf the voltage of the input power to the camera is greater than +24 VDCdamage to the camera can result. If the voltage is less than +12 VDC, thecamera may operate erratically.CAUTIONAn Incorrect Plug Can Damage the 12-pin ConnectorThe plug on the cable that you attach to the camera’s 12-pin connector musthave 12 pins. Use of a smaller plug, such as one with 10 pins or 8 pins, candamage the pins in the camera’s 12-pin connector.CAUTION
