Batco 2035 Assembly Manual
Also see for 20105: Operation manual
                                                                                                                                              | |
Contents
| 
P1512021 R6 1291. Uninstall the existing plastic guard.2. Position the control valve bracket (6) and over-center plastic tank mounts (4) with u-clamps (5) and insert1/2" x 2-1/2" tap bolts (9) and 1/2" nylon locknuts (15). Partially tighten the parts allowing enough room toslide them on the tube for adjustment.3. Attach the control valve (25) to the bracket (6) with two 5/16" x 2-12" bolts (11) and 5/16" nylon locknuts(12).4. Affix the hydraulic tank (29) to the over-center plastic tank mounts (4) with two hose clamps (27).5. Install hydraulic fittings for the valve (19, 20, 21, 23).6. Install hydraulic fittings for the pump (22, 23).7. Connect hoses (1, 31, 32).8. Adjust the hydraulic tank and control valve to minimize slack in the hose and tighten the u-clamps.9. Tie the hydraulic hoses to the tube with 6" cable ties (26). Tighten the u-clamp nuts.10. Install the belt tightener plate (3) to the engine mount with two 7/16" x 1-1/2" carriage bolts (8) and 7/16"nylon locknuts (14) leaving un-tightened for later adjustment.11. Install the small pump mount (28) to the belt tightener plate (3) with two 3/8" x 1-1/2" hex bolts (10) and3/8" nylon locknuts (13), leaving un-tightened for later adjustment.12. Connect the pump (24) to the small pump mount (28) with two 3/8" x 1-1/2" hex bolts (10) and 3/8" nylonlocknuts (13).13. Attach the pulley (18) to the pump (24) and connect the belt (30) to the electric motor pulley and smallpulley (18).14. Adjust the position of the small pulley (18) in line with the electric motor pulley and tighten the belt (30) byadjusting the electric clutch so the belt deflects approximately 1" from a 5 lb force.15. Secure the belt tightener plate (3) and pump mount (28) once they have been sufficiently adjusted.16. Re-install the plastic guard.17. Install the pump guard arm (2) with one 7/16" x 1-1/2" carriage bolt (8) and 7/16" nylon locknut (14) on thebelt tightener plate.18. Attach pump guard (7) to pump guard arm (2) using two 1/4" x 1" tek screws (16) and 1/4" flat washers(17).19. Add hydraulic fluid up to approximately 2" [51 mm] from the tank opening. Do not overfill (leave space attop of tank). Remember to put the tank cap back on afterward.4.31.6 Install the Hydraulic Wet Kit to Electric Drive (2400 Series)Table 56. Hydraulic Wet Kit (2400 Series) ComponentsITEM DESCRIPTION QTY1 Hose 3/4" (6')-1/2" NPT-Hose 12 Hose 1/2" (4'9")-1/2" NPT-1/2" NPT 13 Hose 1/2" (10'10")-1/2" NPT-1/2" NPT 14 Pump Guard Arm 15 Belt Tightener Plate 1PORTABLE GRAIN BELT CONVEYOR – STANDARD 4. ASSEMBLY |
Related manuals for Batco 20105
manualsdatabase
Your AI-powered manual search engine